Capacity: 18" W x 22" H @ 90 degrees
18" W x 15" H @ 45 degrees (L)
18" W x 14" H @ 45 degrees (R)
Blade: 1.25" x 15' x .042"
Motor: 5 HP
The Control Console is located on the front of the saw for operator convenience.
The mitering capability is an easy adjustment powered from the console with LED Angle Readout displayed. This allows the operator to change angles quickly and accurately
The main vise easily adjusts into position then clamps at the turn of a switch holding the material in place to ensure accurate cuts. The wear-plates on the vise and saw bed are heavy-duty and easily replaceable.
The clamping pressure is easily adjusted to clamp various materials.
Blade speed can be adjusted with an infinitely variable speed drive from the console with push button controls. The blade speed is shown on the console with LED Readout.
The saw arm Feed Rate can be adjusted from zero to 3 inches per second. Cutting pressure can be adjusted for effective metal removal rates.
The Powered Moveable Guide Arm provides optimum blade support as material size changes. It quickly adjusts the guides that hold the blade securely, providing straighter cuts and longer blade life.
The saw has a totally built-in coolant system with sealed coolant pump with coolant that is dispensed through a flex-tube nozzle to flood the center of the cut.
Boltable side wings are included to return the coolant to the saw.
The Blade Guide System incorporates side and back blade guides that utilize carbide inserts for long wear, stability and maximum blade support.
The Air Powered Blade Tensioner maintains proper blade tension at all times during the cut, compensating for blade stretch. It makes blade changing done in minutes.
A shaft-driven Blade Brush is standard for positive removal of metal chips that lodge in the blade gullets. This system ensures a cleaner blade, more accurate cuts and prolonged blade life.
The saw is equipped with a safety Emergency Stop cut-off switch. This allows the operator to closely monitor the cutting process and quickly stop it if needed.
An optional second main vise is used for additional clamping and works in conjunction with the main clampingn vise.
An optional Laser Light indicates either above or below where the blade will enter the material for the cut.
The patented Cut Watcher System monitors the cut for squareness to a pre-set deviation value. The system shuts down the saw when the pre-set value is exceeded. This is a must for production cutting. *Reduces Vertical Capacity by 1"
An Optional Swing-Away Top Clamp can be added to the main vise for vertical clamping of structural shapes and when entire "mill bundles" are to be cut.
The optional spray mist system lubricates the blade with a mist that is adjustable at a rate of 4 - 200 pulses per minute, pushing the mix of oil/air out of the delivery line to the nozzle.